Yes, we recommend that a bromide bank be kept in every pool that uses a THUNDER ozonator.  If you must have no chemicals in your water, then try using THUNDER without Sodium Bromide.  A bromide reserve is created by adding just 3 lb. of sodium bromide (Bromine Salt) to your pool water for every 10,000 gallons.  Sodium bromide is a salt and not a bromine sanitizer.  This allows the ozonator to activate the bromide ions as they come in contact with ozone, as ozone is an oxidizer and any oxidizer can activate Sodium Bromide.  A small bromine residual of .1 to .5 ppm may develop providing more efficient sanitation, and better and clearer water quality.  This low level of bromine will not be noticeable or cause any negative problems associated with the use of chemicals.  Once or twice a year a little more sodium bromide is added to the pool water to maintain the bromide reserve as water is replaced due to splash out and back washing.  Sodium bromide is a salt and stays in the water and can be used over and over again.  This is free additional sanitation as it costs nothing extra to produce once the bromide reserve is established.  This also provides an easy method of testing the water with low ppm chlorine or bromine test kits.

They are easily installed to new or existing pools.  If using THUNDERSTORM model TMIS with THUNDER or model TMIK one tee fitting is installed before the filter and one tee is installed after the filter creating a bypass loop around the filter.  The in-line injector (venturi) is installed in the bypass loop, and the power is wired to the pump timer circuit.  If using model T24MIS the two tees are installed after the filter with the check valve between the two tees.  The small pump, injector, and tubing are connected in a bypass loop connected to the two tees.  Both types of installation do not restrict the water flow.  The ozone tubing from THUNDER is connected to the injector included with your injector system.  The injector sucks the ozone out of  the ozone generator as water passes rapidly through the injector and then ozone is mixed completely with water in the mixing injector system.

We highly recommend using one of our Sunshine Ionizers with Thunder for the very best water quality.  By using both it is possible to eliminate using chlorine or any other sanitizer.  The ozone generator must be a properly sized high output generator and used with our THUNDERSTORM injector system model TMIS, or with model T24MIS, and with an ionizer.  With an ionizer and an ozone generator algae problems will be a thing of the past because the ionizer eliminates algae.  See our Sunshine Ionizer page for more information on ionizers.  If you use ozone without an ionizer you will need to maintain 1 to 3 ppm chlorine level or 2 to 4 ppm Bromine level in the water at all times, but you will use much less chlorine or bromine.

For most pools we recommend model T5G and an ionizer such as model SPDS.  The longer the daily circulating pump run time the better if using model TMIS.  At least 8 hours is required.  If operated 12 hours or less a day you should use model T24MIS or you will need a larger system such as a model T10G.  In humid climates with humidity above 70% use a one size larger unit, or provide air from conditioned air to the ozone generator if located near the house.  This is easy to do with just a few feet of vinyl tubing.  Large commercial pools should use multiple T10G systems and one of our large commercial ionizers.

You will need to know if your filter pump is connected to 120 or 240 volts, and if your filtration plumbing is
1 1/2" or 2".  THUNDER voltage can not be changed, so you must order the proper voltage.  Do not order an indoor model if it needs to be installed outdoors.